Ford Mustang (1999-2004) Service Manual: Accessory Drive Belt - 4.6L (2V) and (4V)
Removal and Installation
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
Cobra
2. Remove the supercharger drive belt cover.
3. Rotate the supercharger belt tensioner clockwise and remove the supercharger belt.
4. Remove the coolant hose mounting bolt.
5. Remove the belt idler support bracket assembly.
6. Remove auxiliary crankshaft pulley. For additional information, refer to Section.
All engines
7. Rotate the belt tensioner and remove the accessory drive belt.
8. NOTE: Make sure the accessory drive belt is correctly installed on each pulley.
To install, reverse the removal procedure.
- Refer to Accessory Drive and Accessory Drive-Cobra for accessory drive belt routing.
Accessory Drive Belt - 3.8L
Removal and Installation 1. Rotate the drive belt tensioner counterclockwise and remove the drive belt. 2. NOTE: Make sure the drive belt is correctly installed on each pulley. To install, reverse ...Supercharger Belt
Removal and Installation 1. Remove the supercharger drive belt cover. 2. Rotate the supercharger belt tensioner clockwise and remove the supercharger belt. 3. To install, reverse the removal proc ...Other materials:
Inspection and Verification
1. Verify the customer concern by operating the wiper/washer system.
2. Visually inspect for obvious signs of mechanical and electrical
damage.
Visual Inspection Chart
Mechanical
Electrical
Hoses to windshield washer pump
Wiper l ...
Diagnosis By Symptom
Special Tool(s)
Transmission Fluid Pressure
Gauge
307-004 (T57L-77820-A)
Air Test Plate, Transmission
307-246 (T92P-7006-A)
Breakout Box, EEC-V Control
System
418-049 (T94L-50-EEC-V) or
equivalent
MLP- ...
Installation
1. NOTE: A new torque converter drain plug must be used.
Install the torque converter drain plug.
2. Install the torque converter housing plug.
3. CAUTION: If installing a new filter, and the seal remains in the
main control bore,
carefully use a small ...