Ford Mustang (1999-2004) Service Manual: Supercharger Belt

Removal and Installation

1. Remove the supercharger drive belt cover.

Supercharger Belt

2. Rotate the supercharger belt tensioner clockwise and remove the supercharger belt.

Supercharger Belt

3. To install, reverse the removal procedure.

    Accessory Drive Belt - 4.6L (2V) and (4V)
    Removal and Installation Mach I 1. Remove the air intake scoop. For additional information, refer to Section. Cobra 2. Remove the supercharger drive belt cover. 3. Rotate the supercharger belt tensi ...

    Accessory Drive Belt Tensioner - 3.8L
    Removal and Installation 1. Remove the drive belt. For additional information, refer to Accessory Drive Belt-3.8L in this section. 2. Remove the belt tensioner. Remove the bolt. 3. To install, ...

    Other materials:

    Installation
    1. CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the pad lining material. Do not install contaminated pads. NOTE: Install all hardware supplied with pad kits. Install the pads. 1. Install the new pad slippers. ...

    Disassembly
    1. Remove the driveshaft (4602). For additional information, refer to Driveshaft in this section. 2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws of a vise or similar holding fixture. Denting or localizing fracture ca ...

    Key Programming - Enable/Disable Spare Key Programming
    Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent diagnostic tool NOTE: The spare key programming switch is a diagnostic tool programmable switch that provides the ca ...