Ford Mustang (2005-2014) Owners Manual: Daytime running lamps

WARNING: Always remember to turn on your headlamps at dusk or during inclement weather. The Daytime Running Lamp (DRL) system does not activate the tail lamps and generally may not provide adequate lighting during these conditions. Failure to activate your headlamps under these conditions may result in a collision.

The system switches the headlamps on with a reduced output (vehicles equipped with halogen headlamps) or turns the front fog lamps on (vehicles equipped with HID headlamps) in low light situations.

To switch the system on:

1. Switch the ignition on.
2. Switch the lighting control to the off, autolamp or parking lamp position.
3. Make sure the transmission selector lever is not in position P.
4. Make sure the parking brake is disengaged.

    Headlamp exit delay
    You can set the delay time to keep the headlamps on for up to three minutes after the ignition is turned off. Follow the steps below to change the delay time (Steps 1 through 6 must be done within 10 ...

    Front fog lamps
    The fog lamps can be turned on when the lighting control is pulled toward you and in the headlamps, parking lamps or autolamps positions. The fog lamps will not operate when the high beams are activ ...

    Other materials:

    Interior mirror
    WARNING: Do not adjust the mirror when your vehicle is moving. Note: Do not clean the housing or glass of any mirror with harsh abrasives, fuel or other petroleum or ammonia based cleaning products. You can adjust the interior mirror to your preference. Some ...

    Transmission (Assembly)
    Special Tool(s) Dial Indicator with Bracketry 100-002 (TOOL-4201-C) or Equivalent Gauge, Clutch Housing 308-021 (T75L-4201-A) Extension Housing Seal Replacer 308-227 (T94P-7657-A) Holding Fixture 307-0 ...

    Synchronizers
    Disassembly and Assembly NOTE: This procedure applies to all synchronizer assemblies. 1. Scribe an alignment mark on the sliding sleeve and the hub for assembly reference. 2. Remove the sliding sleeve, then remove the synchronizer struts and the springs. 3 ...