Ford Mustang (1999-2004) Service Manual: Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube - Mach I
Removal
1. Remove the air intake scoop. For additional information, refer to Section.
2. Disconnect the exhaust gas recirculation (EGR) tube from the EGR valve.
3. With the vehicle in NEUTRAL, position it on a hoist.
4. Disconnect the EGR tube from the exhaust manifold.
5. Disconnect the hoses and remove the tube from the vehicle.
Installation
1. To install, reverse the removal procedure.
Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube - Cobra
Removal and Installation 1. Remove the EGR valve. For addditional information, refer to Exhaust Gas Recirculation (EGR) Valve-Cobra in this section. 2. With the vehicle in NEUTRAL, position it on ...Differential Pressure Feedback Exhaust Gas Recirculation (EGR) System
Removal and Installation 1. NOTE: The 4.6L (2V) is shown. The 4.6L (4V) and 3.8L are similar. NOTE: Bolts may be used in place of nuts on some applications. Remove the differential pressure fee ...Other materials:
Removal
Convertible
1. For removal of the back window glass, refer to Section.
Coupe
WARNING: To prevent glass splinters from entering eyes or
cutting hands, wear safety
glasses and heavy gloves when cutting glass from the vehicle.
2. Remove the roof side ...
Pinpoint Test A: The Air Bag Warning Indicator Is Illuminated Continuously
- RCM
Disconnected, Inoperative or Lost/Low Ignition Feed
Normal Operation
NOTE: During normal operation the air bag indicator will be lit continuously
for 6 seconds after the
ignition switch is placed in the RUN position and after five cycles of a lamp
fault code (LFC) if a fault
exists. Be sure to cycle the ignit ...
Evaporative Emissions (Diagnosis and Testing)
Special Tool(s)
Evaporative Emission System
Leak Tester
310-F007 (134-00056) or
equivalent
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent scan
tool
Evaporative Em ...