Ford Mustang (1999-2004) Service Manual: Differential Pressure Feedback Exhaust Gas Recirculation (EGR) System
Removal and Installation
1. NOTE: The 4.6L (2V) is shown. The 4.6L (4V) and 3.8L are similar.
NOTE: Bolts may be used in place of nuts on some applications.
Remove the differential pressure feedback EGR.
1. Disconnect the connector.
2. Remove the hoses.
3. Remove the nuts and the differential pressure feedback EGR.
2. To install, reverse the removal procedure.
Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube - Mach I
Removal 1. Remove the air intake scoop. For additional information, refer to Section. 2. Disconnect the exhaust gas recirculation (EGR) tube from the EGR valve. 3. With the vehicle in NEUTRAL, ...Exhaust Gas Recirculation (EGR) Vacuum Regulator Solenoid
Mach I vehicles 1. Remove the air intake scoop. For additional information, refer to Section . All vehicles 2. Remove the exhaust gas recirculation (EGR) vacuum regulator solenoid. Disconnec ...Other materials:
Technical specifications
Wheel Lug Nut Torque Specifications
WARNING: When a wheel is installed, always remove any
corrosion, dirt or foreign materials present on the mounting
surfaces of the wheel or the surface of the wheel hub, brake drum or
brake disc that contacts the wheel. Make ...
Assembly
1. NOTE: Lubricate direct clutch piston inner seal and seal protector
with petroleum jelly.
Using the special tool, install the inner piston seal.
Install the seal with sealing lip facing down.
2. Install the clutch piston outer seal so that when the pis ...
Engine - 3.8L
General Specifications
a - 20-200 seconds to leakdown 3.18 mm (0.125 in) with 225 Newtons (50
pounds) load and tappet filled
with leak-down fluid.
Torque Specifications
a - Refer to the procedure in this section
b - Advance one-half turn aft ...