Ford Mustang (1999-2004) Service Manual: Removal
1. Remove the roller followers. For additional information, refer to Roller Followers in this section.
2. Remove the LH timing chain for the LH side and both timing chains for the RH side. For additional information, refer to Timing Drive Components in this section.
3. Install the special tool.
4. Remove the exhaust camshaft sprocket and the intake camshaft bolt, washer and spacer.
5. Remove the special tool.
6. Compress the tensioner and install a lock pin.
7. Remove the timing chain, the sprocket, and intake camshaft sprocket spacer.
8. NOTE: LH shown; RH similar.
Remove the bolts.
9. CAUTION: The outer bolts on the outer cam bearing cap (exhaust) are longer and must be returned to the same location or engine damage may occur.
NOTE: Identify the camshaft to cylinder head location. Caps are not interchangeable.
Remove the bolts and the camshaft bearing cap assemblies.
10. Remove the camshafts.
Camshaft
Special Tool(s) Holding Tool, Camshaft 303-446 (T93P-6256-AHR) Material Item Specification Super Premium SAE 5W-20 Engine Oil XO-5W20-QSP or equivalent WSS-M2C153- ...Installation
1. NOTE: LH shown; RH similar. Install the camshafts. Lubricate the camshafts with clean engine oil. 2. Install the camshaft bearing cap assemblies and tighten the bolts in the sequence shown. ...Other materials:
Rear View Mirrors
Torque Specifications
Rear View Mirrors
The rear view mirror system consists of the following components:
exterior rear view mirror
exterior rear view mirror control
exterior rear view mirror glass
exterior rear view mirror motor
interior ...
Manual Transmission and Clutch (Description and Operation)
The primary function of the clutch is to couple and uncouple engine
power to the transmission upon
driver command. For additional information, refer to Section.
Clutch Disc and Clutch Pressure Plate - 3.8L
Clutch Disc and Clutch Pressure Pl ...
Installation
1. Install the RH engine insulator.
Install the nuts.
Install the bolts.
2. Install the LH engine insulator.
3. Connect the engine ground strap.
4. Install the bracket.
5. Lower the vehicle.
6. Lower the engine.
7. Raise the vehicle.
8. Ins ...