Ford Mustang (1999-2004) Service Manual: Reverse Sun Gear
Disassembly
1. Remove the reverse clutch sun gear assembly and the No. 4 forward clutch hub bearing and race.
2. Remove the forward clutch sun gear assembly and the No. 5 forward clutch sun gear bearing and race.
Assembly
1. The forward clutch sun gear and reverse sun gear assembly are assembled as part of the transmission assembly procedure.
Planetary Gear Support Assembly and Planetary One-Way Clutch
Disassembly and Assembly 1. NOTE: Inspect the outer and inner races for scores or damaged surface areas where rollers contact the races. Inspect the rollers and springs for excessive wear ...Output Shaft and Direct Clutch Cylinder
Special Tool(s) Compressor, Clutch Spring 307-015 (T65L-77515-A) Protector, Piston Seal 307-080 (T80L-77234-A) Protector, Transmission Direct Clutch Outer Flui ...Other materials:
Transmission (ASSEMBLY)
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C)
Rubber Tip Air Nozzle
100-D009 (D93L-7000-A)
Alignment Gauge, TR Sensor
307-351 (T97L-70010-A)
Slide Hammer
100-001 (T50T-1 ...
Removal
1. Disconnect the battery ground cable. For additional information, refer
to Section.
2. Raise and support the vehicle. For additional information, refer to
Section.
3. Place a drain pan under the transmission fluid pan.
4. Drain transmission fluid.
...
Key Programming - Additional Key With One Programmed
Key
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent
diagnostic tool
NOTE: This procedure is used when a customer needs to have an additional key
programmed into the
veh ...