Ford Mustang (1999-2004) Service Manual: Automatic Transaxle/Transmission
General Specifications
a - MERCON V is not interchangeable at this time with the current MERCON fluids. Check the transmission fluid level indicator to determine the correct fluid and refer to the Workshop/Owner publication to determine the correct service interval for the specific vehicle.
Torque Converter End Play
Band and Clutch Application Chart
A = Applied
H = Holding
O/R = Overrunning
Stall Speed
Shift Speeds 4.6L 4V MACH 1 (3.55:1 Axle Ratio)
Shift Speeds 4.6L 2V HO (3:27:1 Axle Ratio)
Shift Speeds 3.8L (3:27:1 Axle Ratio)
Shift Speeds 3.8L (3:08:1 Axle Ratio)
Sensor Resistance Readings
Selective Thrust Washer No.1
Forward Clutch Pack
Reverse Clutch Pack
Direct Clutch Pack
Intermediate Clutch Pack
Torque Specifications
- Transmission Description (Description and Operation)
- Identification Tags
- Range Selection
- Shift Patterns
- Torque Converter (Description and Operation)
- Geartrain
- Apply Components
- Hydraulic System
- Transmission Electronic Control System
- Diagnostic Strategy
- Preliminary Inspection
- Shift Point Road Test
- Torque Converter Diagnosis
- Diagnostics
- Output State Control (OSC) Mode
- Transmission Drive Cycle Test
- Diagnostic Trouble Code Charts
- Transmission Connector Layouts
- Pinpoint Tests - OSC Equipped Vehicles
- Special Testing Procedures
- Leakage Inspection
- Transmission Fluid Cooler
- Diagnosis By Symptom
- Transmission Fluid Cooler - Backflushing and Cleaning
- Transmission Fluid Drain and Refill
- Fluid Pan, Gasket and Filter
- Transmission Filler Tube
- Main Control Valve Body
- Extension Housing Seal and Gasket
- Electronic Pressure Control (EPC) Solenoid
- Manual Control Lever Shaft and Seal
- Digital Transmission Range (TR) Sensor
- Reverse Servo Assembly
- Overdrive Servo
- 1-2 Accumulator
- 2-3 Accumulator
- Transmission Support Crossmember
- Transmission (REMOVAL)
- Transmission (DISASSEMBLY)
- Main Control Valve Body
- Pump and Intermediate Clutch Piston
- Intermediate One-Way Clutch
- Reverse Clutch
- Forward Clutch Cylinder
- Planetary Gear Support Assembly and Planetary One-Way Clutch
- Reverse Sun Gear
- Output Shaft and Direct Clutch Cylinder
- Torque Converter (Disassembly and Assembly of Subassemblies)
- Torque Converter Cleaning And Inspection
- Torque Converter Leak Check
- Torque Converter Impeller to Pump Stator Interference Check
- Torque Converter End Play Check
- Torque Converter Turbine to Pump Stator Interference Check
- Transmission (ASSEMBLY)
- Transmission (INSTALLATION)
Transmission Description (Description and Operation)
The 4R70W has the following features: Wide ratio gears Four speeds Rear wheel drive Automatic Electronic shift Torque converter clutch control Line pressure controls The t ...Other materials:
Safety precautions
WARNING: Do not overfill the fuel tank. The pressure in an
overfilled tank may cause leakage and lead to fuel spray and fire.
WARNING: The fuel system may be under pressure. If you hear
a hissing sound near the fuel filler inlet, do not refuel until the
sound ...
Air Conditioning (A/C) Compressor Bracket - 3.8L
Removal and Installation
1. Remove the A/C compressor (19703). For additional information, refer to
Air Conditioning (A/C)
Compressor-3.8L in this section.
2. Remove the three bolts and one nut.
3. Remove the A/C compressor mounting bracket.
4. To install ...
Material
Item
Specification
Threadlock and
Sealer
E0AZ-19554-AA
WSK-M2G351-A5 (type
II)
Shoulder Bolt Kit
F5ZZ-76539A04-A
-
NOTE: Before starting the adjustment process, inspect the top for damage,
make sure that the door
window glass ...