Ford Mustang (1999-2004) Service Manual: Trim Panel - Quarter, Coupe
Removal and Installation
1. Remove the upper quarter trim panel. For additional information, refer to Trim Panel-Upper Quarter in this section.
2. Remove the scuff plate.
3. Remove the pin-type retainers.
4. Lower the rear seat backrests.
5. Remove the bolts and the rear seat backrest bolster.
6. Remove the quarter trim panel pin-type retainers.
7. Remove the lower quarter trim panel.
8. To install, reverse the removal procedure.
Trim Panel - Door
Removal All vehicles 1. CAUTION: Use a shop towel or similar material between the tool and the front door trim panel or damage to the front door trim panel may occur. Position the window re ...Trim Panel - Quarter, Convertible
Special Tool(s) Safety Belt Bolt Bit 501-010 (T77L-2100-A) Removal and Installation 1. Lower the convertible top to the full down position. 2. Remove the rear seat cushion. 3. ...Other materials:
Mass Air Flow (MAF) Sensor - 3.8L
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing
element and housing are
calibrated as a unit and must be repaired as a complete assembly. Do not
damage the sensing
element (internal to housing) or possible failure to the mass air f ...
Inspection and Verification
WARNING: A vehicle equipped with a Traction-Lok differential will
always have both
wheels driving. If, while the vehicle is being serviced, only one wheel is
raised off the ground
and the rear axle is driven by the engine, the wheel on the ground could drive ...
Recreational towing
Note: Do not tow with the Shelby GT500 model. It cannot tow a trailer.
Note: Do not exceed the trailer weight for your vehicle configuration
listed in the chart below.
Note: Make sure to take into consideration trailer frontal area. Do not
exceed 12 feet2 (1 ...