Ford Mustang (1999-2004) Service Manual: Interior Trim and Ornamentation

General Specifications

General Specifications

Torque Specifications

Torque Specifications

Interior Trim

The interior trim consists of:

  • A-pillar lower trim panels
  • door trim panels
  • headliner (coupe)
  • package tray trim panel (coupe)
  • quarter trim panels
  • upper quarter trim panels (coupe)
  • scuff plates
  • sun visors
  • tether anchor covers (coupe)
  • windshield side garnish mouldings
Luggage Compartment Lid - Hinge
Removal 1. Disconnect the electrical connector. 2. Remove the lift cylinder. 3. Remove the luggage compartment lid hinge bolts. 4. NOTE: Remove the sealer around the luggage compartment lid hi ...

Trim Panel - Door
Removal All vehicles 1. CAUTION: Use a shop towel or similar material between the tool and the front door trim panel or damage to the front door trim panel may occur. Position the window re ...

Other materials:

Removal
1. Remove brake master cylinder filler cap (2162). Check brake fluid level in brake master cylinder reservoir (2K478). Remove fluid until brake master cylinder reservoir is half full. 2. Raise and support the vehicle. 3. Remove the wheel and ...

Piston - Selection
NOTE: The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston. 1. Select a piston size based on the cylinder bore. 2. NOTE: For precision fit, new pistons are divided into three categories within each size ...

Installation
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions and notes at the beginning of the removal procedure. 1. Disconnect the battery ground cable and wait at least one minute. For additional information, re ...