Ford Mustang (2005-2014) Owners Manual: Vehicle certification label

The National Highway Traffic Safety Administration Regulations require that a Safety Compliance Certification Label be affixed to a vehicle and prescribe where the Safety Compliance Certification Label may be located.

The Safety Compliance Certification Label shall be affixed to either the door hinge pillar, the door latch post, or the edge of the door near the door latch, next to the driver’s seating position.

    Vehicle identification number
    The vehicle identification number is located on the driver’s side instrument panel. Please note that in the graphic, XXXX is representative of your vehicle identification number. The Vehicle Ident ...

    Transmission code designation
    You can find a transmission code on the Safety Compliance Certification Label. The following table tells you which transmission each code represents. ...

    Other materials:

    Canister Vent Solenoid Closing Procedure
    Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent scan tool CAUTION: The canister vent solenoid must not be energized for more than nine minutes at one time. Once the ...

    Universal Joints
    The universal joints are: lubed-for-life design and require no lubrication. equipped with nylon thrust washers, located at each base of the bearing cup, which control end play, position the needle bearing and improve grease movement.   Item ...

    Installation
    Using special tool 205-054 NOTE: This is the preferred method for installing the pinion bearing cups. If necessary, proceed to Using special tools 205-153, 205-054, and 205-D055 in this procedure for an alternate method. 1. Position the special tools and th ...