Ford Mustang (1999-2004) Service Manual: Cylinder Head LH

Special Tool(s)

Remover, Power Steering Pump Pulley 211-016 (T69L-10300-B)
Installer, Power Steering Pump Pulley 211-009

Material

Cylinder Head LH

Exhaust Manifold RH
Removal and Installation 1. Disconnect the battery negative cable. For additional information, refer to Section. 2. Remove the air cleaner outlet pipe. For additional information, refer to Sect ...

Removal
1. Disconnect the battery negative cable. 2. Drain the engine cooling system. 3. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold-LH in this section. 4. ...

Other materials:

Installation
1. Install the upper intake manifold gasket. 2. Install the intake manifold and bolts in the sequence shown. 3. Install the PCV valve-to-intake manifold tube. 4. Connect the vacuum hoses and the electrical connector to the EGR vacuum regulator soleno ...

Blower Motor
Removal 1. Disconnect the jumper wire. 2. Disconnect the main harness. 3. Remove the screws. 4. Separate the cover from the motor. 5. Separate the motor from the housing. 6. Disconnect the jumper from the motor. Remove the blower motor. Installa ...

Temporary mobility kit
Note: The temporary mobility kit sealant compound in the canister is to be used for one tire only. See your Ford authorized dealer for additional replacement sealant canisters. The kit is located in the spare tire well in the trunk. The kit consists of an ai ...