Ford Mustang Service Manual: Engine Ignition - 3.8L

General Specifications

Torque Specifications


Torque Specifications

Engine Ignition (Description and Operation)


Starter Motor - 4.6L
Starting System (Description and Operation) Starter Motor The starter motor is a 12-volt unit that has the starter solenoid mounted on the drive end housing and functions as follows: The current fl ...

Engine Ignition (Description and Operation)
Engine Ignition (Description and Operation) The ignition coil (12029), which is mounted on the upper intake manifold, can be described as a coil pack containing three separate coil units. Each coil u ...

Other materials:

Installation
Removal 1. Disconnect the battery negative cable. 2. Drain the engine cooling system. 3. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold-LH in this section. 4. Remove the lower intake manifold. For additional i ...

Starter Motor - 3.8L
Starting System (Description and Operation) Starter Motor The starter motor is a 12-volt unit that has the starter solenoid mounted on the drive end housing and functions as follows: The current flows through the solenoid energizing coil until the solenoi ...

Component Tests
Principles of Operation Power Window Control NOTE: Battery power and ground must be removed before disconnecting the GEM connectors to avoid setting false DTCs. The driver power window one-touch down operation is controlled by the generic electronic m ...