Ford Mustang (1999-2004) Service Manual: Exhaust System
Torque Specifications
- Exhaust System (Description and Operation)
- Exhaust System (Diagnosis and Testing)
- Muffler - 3.8L
- Muffler - 4.6L (2V)
- Muffler - 4.6L (4V)
- Dual Converter Y-Pipe - 3.8L
- Dual Converter H-Pipe - 4.6L (2V and 4V)
Transmission (Installation)
Material
Item
Specification
DEXRON III (ATF)
Transmission Fluid
XT-2-QDX or equivalent
DEXRON III
Pipe Sealant with Teflon
D8AZ-19554-A or equivalent
WSK-M2G350-
A2
...
Exhaust System (Description and Operation)
WARNING: The normal operating temperature of the exhaust system is very
high. Never
attempt to repair any part of the system until it has cooled. Be especially
careful when working
around the three ...
Other materials:
Installation
1. Install the bearing, snap ring, hub and dust shield. For additional
information, refer to Wheel
Hub-Cobra in this section.
2. Install the knuckle.
1. Position the knuckle on the lower suspension arm and bushing.
2. Install a new bolt and a new nut. Do ...
Installation
1. Clean the A/C disc and field coil and pulley mounting surfaces.
2. CAUTION: Do not use air tools. The A/C clutch field coil can be easily
damaged.
Install the A/C clutch field coil.
1. Place the A/C clutch field coil on the A/C compressor with the A/C
...
Rear Drive Axle/Differential - Ford 8.8-Inch IRS
General Specifications
Torque Specifications
a: Use Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford
specification WSKM2G349-
A1.
b: With pinion flange yoke seal. ...
