Ford Mustang (1999-2004) Service Manual: Output Shaft
Special Tool(s)
 |
Puller, Bearing 205-D064 (D84L-1123-A) |
 |
Adapter for 303-224 (Handle) 205-153 (T80T-4000-W) |
 |
Installer, Output Shaft Rear Bearing 308-401 |
 |
Remover/Installer, Bearing Tube 308-025 (T75L-7025-C) |
Input Shaft and Bearing
Special Tool(s)
Plate, Bearing/Oil Seal
205-090 (T75L-1165-B)
Puller, Bearing
205-D064 (D84L-1123-A)
Installer, Drive Pinion Bearing
Cone
205-004 (T53T-4621- ...
Disassembly
1. CAUTION: Hand tighten the special tool to prevent gear damage.
CAUTION: Support the output shaft while using the press to prevent
damage to the
shaft or gears.
Using the special tool and ...
Other materials:
Throttle Position (TP) Sensor
Removal
NOTE: The 3.8L engine is shown; the 4.6L (2V) is similar.
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the throttle position (TP) sensor.
Disconnect the connector.
Remove the screws, ...
Inspection and Verification
1. Verify the customer concern by operating the wiper/washer system.
2. Visually inspect for obvious signs of mechanical and electrical
damage.
Visual Inspection Chart
Mechanical
Electrical
Hoses to windshield washer pump
Wiper l ...
Manual Transmission
The T5OD 5-speed transmission:
fifth speed gear functions as an overdrive gear.
forward gears are synchronized and helical cut.
shift interlock system prevents the engagement of more than one
gear.
Transmission, Manual Five-Speed
T ...
