Ford Mustang (1999-2004) Service Manual: Universal Joint - Single Cardan, Flange Yoke

Special Tool(s)

Installer/Remover, C Frame and Screw 205-086 (T74P-4635-C)
Assembly
1. NOTE: Universal joint service kits are to be installed as complete assemblies only. Do not mix components from other U-joint kits. Install the bearing cup. 1. Start a new bearing cup into the d ...

Disassembly
1. Remove the driveshaft (4602). For additional information, refer to Driveshaft in this section. 2. CAUTION: Under no circumstances is the driveshaft assembly to be clamped in the jaws of a vise o ...

Other materials:

Handles, Locks, Latches and Mechanisms
General Specifications Torque Specifications LOCK REPAIR/REPLACEMENT SPECIFICATIONS ...

Switch - Key-In-Ignition Warning
Removal 1. Remove the ignition switch lock cylinder. 1. Insert the ignition key and turn to the RUN position. 2. Insert a punch in the access hole of the steering column and press the release tab while pulling out the ignition switch lock cy ...

Installation
1. CAUTION: Install the brake pads in full axle sets. Do not install new brake pads on only one side of vehicle. Install the new slipper and brake pads. 2. Position the caliper on the anchor plate and install the bolts. 3. Install the wheel and tire ...