Ford Mustang (1999-2004) Service Manual: Accessory Drive Belt Idler Pulley - 3.8L
Removal and Installation
1. Remove the drive belt. For additional information, refer to Accessory Drive Belt-3.8L in this section.
2. Remove the belt idler pulley.
- Remove the bolt.
3. To install, reverse the removal procedure.
Supercharger Belt Tensioner
Removal and Installation
1. Remove the supercharger drive belt cover.
2. Rotate the supercharger belt tensioner clockwise and remove the
supercharger belt.
3. Remove the bolts and the supercharger ...
Accessory Drive Belt Idler Pulley - 4.6L (2V) and (4V)
Removal and Installation
Mach I
1. Remove the air intake scoop. For additional information, refer to Section.
Cobra
2. Remove the supercharger drive belt cover.
3. Rotate the supercharger belt tensi ...
Other materials:
Transmission Connector Layouts
Transmission Vehicle Harness Connector
Transmission Internal Harness Connector
Digital Transmission Range (TR) Sensor Connector
Output Shaft Speed (OSS) Sensor Harness Connector
Digital Transmission Range (TR) Senso ...
Communications Network (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 14 , Multiplex Communication Network for
schematic and connector
information.
Special Tool(s)
73 Digital Multimeter or
equivalent
105-R0051
Worldwide Diagnostic System
(WDS)
418-F224,
New Genera ...
Synchronizers
Disassembly and Assembly
NOTE: This procedure applies to all synchronizer assemblies.
1. Scribe an alignment mark on the sliding sleeve and the hub for assembly
reference.
2. Remove the sliding sleeve, then remove the synchronizer struts and the
springs.
3 ...
