Ford Mustang (1999-2004) Service Manual: Clutch And Clutch Field Coil
Special Tool(s)
 |
2-Jaw Puller 205-D026 (D80L-1002-L) or equivalent |
 |
Installer, A/C Compressor Coil 412-065 (T89P-19623-EH) |
 |
Holding Fixture, Compressor Clutch (3.8L vehicles) 412-098 (T94P-19703-AH) |
 |
Holding Fixture, Compressor Clutch (4.6L vehicles) 412-103 (T95L-19703-AH) |
 |
Remover, Differential Bearing 205-116 (T77F-4220-B1) |
 |
Installer, A/C Compressor Field Coil 412-078 (T91L-19623-CH) |
 |
Remover, A/C Compressor Field Coil 412-067 (T89P-19623-FH) |
Air Conditioning (A/C) Compressor Bracket - 3.8L
Removal and Installation
1. Remove the A/C compressor (19703). For additional information, refer to
Air Conditioning (A/C)
Compressor-3.8L in this section.
2. Remove the three bolts and one nut.
3 ...
Removal
1. Remove the A/C compressor (19703). For additional information, refer to
Air Conditioning (A/C)
Compressor-3.8L or Air Conditioning (A/C) Compressor-4.6L in this section.
2. Remove the bolt.
1. ...
Other materials:
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of mechanical and electrical damage.
Visual Inspection Chart
Mechanical
Electrical
Fuel tank
Engine coolant level
Accessory drive belt
Engine oil level
Par ...
Output Shaft Speed (OSS) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. Disconnect the electrical connector.
3. Remove the output shaft speed (OSS) sensor.
4. To install, reverse the removal procedure. ...
Dowels - Flywheel Housing to Block
Removal
1. NOTE: Take care not to damage the flywheel housing to block dowel
holes or the surface areas
around the flywheel housing to block dowel hole during removal.
Remove the two flywheel housing to block dowels using a drift pin where the
flywheel ...
