Ford Mustang (1999-2004) Service Manual: Air Conditioning

General Specifications

General Specifications

Torque Specifications

Torque Specifications

Evaporator Core Housing
Disassembly 1. Remove the evaporator core housing. For additional information, refer to Evaporator Core Housing in this section. 2. Remove the foam weather seal. 3. Remove the screws and remove th ...

Air Conditioning (Description and Operation)
The A/C refrigerant system is a clutch cycling orifice tube type. The system components are: A/C compressor (19703) A/C clutch (2884) A/C condenser core (19712) A/C evaporator core (19860) suct ...

Other materials:

Assembly
1. Install the valve stem seals. 2. Install the valves and the valve springs. 3. CAUTION: Make sure the tool is seated correctly on the valve spring. Apply a small amount of air at a time. This will prevent the tool from shifting and causing damage to the ...

Evaporative Emission Repair Verification Drive Cycle
Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent scan tool Drive Cycle Recommendations NOTE: The following procedure is designed to execute and complete the evap ...

Lamp Assembly - Fog Lamp (GT)
Removal 1. Raise and support the vehicle. 2. Remove the screw. 3. Partially lower the vehicle and remove the fog lamp assembly. 1. Disconnect the electrical connector. 2. Remove the two screws. 3. Remove the fog lamp assembly and replace the bul ...