Ford Mustang (1999-2004) Service Manual: Dowels - Flywheel Housing to Block

Removal

1. NOTE: Take care not to damage the flywheel housing to block dowel holes or the surface areas around the flywheel housing to block dowel hole during removal.

Remove the two flywheel housing to block dowels using a drift pin where the flywheel housing to block dowel is installed in an open hole and a pair of locking pliers where the flywheel housing to block dowel is installed in a blind hole.

Dowels - Flywheel Housing to Block

Installation

1. NOTE: Care should be taken to drive the flywheel housing to block dowel squarely into place until it is fully seated without damaging the surrounding surface areas.

Install all flywheel housing to block dowels by driving them into place using a brass or plastic mallet.

 

    Dowels - Flywheel
    Removal 1. NOTE: Take care not to damage the flywheel dowel holes or the surface areas around the flywheel dowel during removal. Remove the flywheel dowels by using a drift pin where the flywhee ...

    Clutch
    General Specifications Torque Specifications ...

    Other materials:

    Engine (Installation)
    Special Tool(s) Lifting Bracket, Engine 303-D087 (D93P-6001-A1) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Installer Set, Teflon Seal 211-D027 (D90P-3517A) or equivalent Spreader Bar 303-D089 (D9 ...

    Bushing - Stabilizer Bar
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if i ...

    Exhaust Manifold RH
    Special Tool(s) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Support Bar, Engine 303-290-A Removal and Installation 1. Install the special tool. 2. Install the special tools. 3. Raise and support the vehicle. For additional ...