Ford Mustang (1999-2004) Service Manual: Driver Air Bag Module
Special Tool(s)
![]() |
Diagnostic Tool, Restraint System (2 Req'd) 418-F088 (105-R0012) |
Installation
WARNING: To reduce the risk of serious personal injury, read
and follow all warnings,
cautions and notes at the beginning of the removal procedure.
1. WARNING: The tightening torque of the air ...
Removal
WARNING: Always wear safety glasses when repairing an air bag
supplemental restraint
system (SRS) vehicle and when handling an air bag module. This will
reduce the risk of injury
in the even ...
Other materials:
Cylinder Head Temperature (CHT) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information
refer to Section.
2. Disconnect the cylinder head temperature sensor connector.
3. Remove the CHT sensor.
Installation
1. To install, reverse the removal procedure. ...
Push Rods - Inspection
1. CAUTION: Do not attempt to straighten push rods.
Check the ends of the push rods for nicks, grooves, roughness or
excessive wear. Install new
push rods as necessary. Refer to the appropriate section in Group 303 for
the procedure.
The push rods ca ...
Tracing Powder
Tracing powder is used to check both the uniformity of contact and the
tension of a seal against its
sealing surface. These tests are usually done when a suspected air leak/noise
appears to originate
from the seal area or during the alignment and adjustment ...

