Ford Mustang (1999-2004) Service Manual: Engine Ignition - 4.6L (2V)

General Specifications

General Specifications

Torque Specifications

Torque Specifications

Spark Plugs
Special Tool(s) Remover, Spark Plug Wire 303-106 (T74P-6666A) Material Item Specification Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equiva ...

Engine Ignition (Description and Operation)
Eight separate ignition coils (12029): are mounted directly above each spark plug (12405). are controlled by the powertrain control module (PCM) for correct firing sequence. The spark plug ...

Other materials:

Torque Converter Leak Check
Special Tool(s) Leak Tester, Torque Converter 307-421 1. Clean the outside surface of the torque converter. 2. Install the special tool into the converter hub. 3. WARNING: Always follow correct safety procedures while using press. Failure t ...

Fuel Pump Module
Removal and Installation 1. Remove the fuel tank. For additional information, refer to Fuel Tank in this section. 2. NOTE: For installation, tighten the bolts in the sequence shown. Remove the module assembly flange bolts. 3. Clean the area around the fue ...

Planetary Gear Support Assembly and Planetary One-Way Clutch
  Disassembly and Assembly 1. NOTE: Inspect the outer and inner races for scores or damaged surface areas where rollers contact the races. Inspect the rollers and springs for excessive wear or damage. Inspect the spring and cage for bent or damaged ...