Ford Mustang (1999-2004) Service Manual: Engine Mount LH
Special Tool(s)
 |
Lifting Bracket, Engine 303-D088 (D93P-6001-A2) |
 |
Support Bar, Engine 303-290-A |
Removal
1. Install the special tool.
2. Install the special tools.
3. Raise and support the vehicle. For additional information, refer to Section.
4. Remove the two engine mount nuts.
5. Lower the vehicle.
6. Using the special tools, raise the engine.
7. Raise and support the vehicle. For additional information, refer to Section.
8. Remove the engine mount.
Installation
1. To install, reverse the removal procedure.
Engine Mount RH
Special Tool(s)
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Support Bar, Engine
303-290-A
Removal
1. Install the special tool.
2. Install the special tools.
3. Re ...
Cylinder Heads (Removal)
Special Tool(s)
Remover, Crankshaft Vibration
Damper
303-009 (T58P-6316-D)
Remover, Crankshaft Front Oil
Seal
303-107 (T74P-6700-A)
Engine Lift Bracket Set
...
Other materials:
Handles, Locks, Latches and Mechanisms
General Specifications
Torque Specifications
LOCK REPAIR/REPLACEMENT SPECIFICATIONS
...
Rear Drive Halfshafts (Description and Operation)
The rear wheel drive halfshaft system consists of and operates as
follows:
Halfshafts (4K138) transmit engine torque from the rear axle housing to
the rear wheels.
Halfshafts rotate at approximately one-third the speed of a driveshaft
and do not cont ...
Weld Nut Repair - "J" Nut, Restraints Control
Module
(RCM)
WARNING: To avoid accidental deployment and possible personal
injury, the backup
power supply must be depleted before repairing or replacing any front or
side air bag
supplemental restraint system (SRS) components and before servicing,
replacing, ...
