Ford Mustang (1999-2004) Service Manual: Exhaust Manifold - LH

Removal

1. Raise and support the vehicle. For additional information, refer to Section.

2. Remove the LH exhaust manifold flange nuts.

Exhaust Manifold -LH

3. Remove the RH exhaust manifold flange nuts.

Exhaust Manifold -LH

4. Lower the vehicle.

5. NOTE: Discard the exhaust manifold gasket.

Remove the LH exhaust manifold (9431).

  • Remove the nuts.

Exhaust Manifold -LH

Installation

1. NOTE: Install a new gasket.

NOTE: Tighten the nuts in the sequence shown.

To install, reverse the removal procedure.

Exhaust Manifold -LH

 

Exhaust Manifold -LH

 

Exhaust Manifold -LH

    Timing Chain
    Removal 1. Remove the timing cover. For additional information, refer to Engine Front Cover in this section. 2. Remove the camshaft position sensor drive gear. 1. Remove the bolt. 2. Remov ...

    Exhaust Manifold RH
    Removal and Installation 1. Disconnect the battery negative cable. For additional information, refer to Section. 2. Remove the air cleaner outlet pipe. For additional information, refer to Sect ...

    Other materials:

    Steering Column Switches (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 13 , Power Distribution for schematic and connector information. Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic and connector information. Refer to Wiring Diagrams Cell 85 , Headlamps for schematic and co ...

    Inspection and Verification
    WARNING: Never remove the pressure relief cap while the engine is operating or when the cooling system is hot. Failure to follow these instructions can result in damage to the cooling system or engine or personal injury. To avoid having scalding hot coolant ...

    Heater Core Backflushing
    Special Tool(s) Flush Kit 164-R3658 or equivalent Drain Kit 164-R3662 or equivalent Material Item Specification Motorcraft Premium Cooling System Flush VC-1 or equivalent ESR-M14P7-A Motorcraft Premium ...