Ford Mustang (1999-2004) Service Manual: Handles, Locks, Latches And Mechanisms (Description and Operation)
Lock Cylinders
Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.
Latch System
The door latch system consists of:
- front door latch remote control and cable assembly
- front door latch (21812)
- door latch control rod knob (21850)
- door handle (22404) and front door latch actuating rod (22152)
- lock cylinder (22050) and front door latch control cylinder rod (22134)
- door latch striker plate (22008)
- front door latch remote control cable (221A00)
- door lock cylinder (21990)
- window regulator switch plates (14524)
- adjunct actuator (218B20)
- circuit wiring and circuit protection
- front door lock switch (14017)
- luggage compartment lid latch with mechanical interior release handle and cable
- luggage compartment lid lock cylinder
Luggage Compartment Lid Remote Control Lock Switch
The luggage compartment remote control system consists of:
- luggage compartment remote control lock switch (19C542) located in the glove compartment (06010)
- remote control lock actuator (part of the luggage compartment lid latch)
- circuit wiring and circuit protection
Locks, Latches And Mechanisms
Refer to Section for power door lock and luggage compartment lid remote control lock switch diagnostics.
Handles, Locks, Latches and Mechanisms
General Specifications
Torque Specifications
LOCK REPAIR/REPLACEMENT SPECIFICATIONS
...
Latch - Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Release the actuating rods by opening the clips.
3. Using a screwdriver, release the lock cyli ...
Other materials:
Inspection and Assembly Requirements - Following an
A/C
Compressor Failure
CAUTION: To prevent refrigerant system contamination and possible
failure of the new
A/C compressor, carry out the following procedures.
1. NOTE: A dirty A/C evaporator core orifice or a condenser to
evaporator tube containing black
refrigerant oil and parti ...
Pump - CII
Special Tool(s)
Teflon Seal Replacer Set
211D027 (D90P-3517-A) or
equivalent
Removal and Installation
1. Disconnect the power steering hose. Remove and discard the seal ring.
2. Disconnect the power steering hose.
3. Remove the pulley.
...
Window Glass - Quarter, Convertible
Removal
1. Remove the quarter trim panel. For additional information, refer
to Section.
2. Disconnect the connectors and remove the screw.
3. Remove the screw.
4. Remove the screw and the speaker.
5. Disconnect the electrical connector.
6. Remo ...
