Ford Mustang (1999-2004) Service Manual: Oil Pump Screen and Pickup Tube

Removal and Installation

1. Remove the oil pan (6675). For additional information, refer to Oil Pan in this section.

2. Remove the oil pump screen cover and tube (6622) and discard the gasket.

1. Remove the nut.

2. Remove the two bolts.

3. Remove the oil pump screen cover and tube.

4. Remove and discard the gasket.

Oil Pump Screen and Pickup Tube

3. To install, reverse the removal procedure.

Oil Pump Screen and Pickup Tube

    Flexplate
    Removal and Installation 1. Remove the transmission. 2. Remove the six bolts retaining the flexplate to crankshaft, and remove the flexplate. 3. To install, reverse the removal procedure. ...

    Other materials:

    Traction Control
    PRINCIPLES OF OPERATION The traction control system helps avoid drive wheel spin and loss of traction. If your vehicle begins to slide, the system applies the brakes to individual wheels and, when needed, reduces engine power at the same time. If the wheels s ...

    Component Tests
    Idle Air Control (IAC) Valve 1. Open the hood. 2. NOTE: Key symptom is elevated idle speed while noise is occurring. NOTE: "Snapping" the throttle can induce the noise. Verify the condition by operating the vehicle for a short time. 3. Inspect the IAC valv ...

    Air Conditioning (A/C) System Check - Retail Procedure
    NOTE: This Retail Procedure is not eligible for claiming on Ford paid repairs (warranty and ESP). NOTE: The engine should be run at idle for 10 minutes with the air conditioning on and set to MAX A/C before carrying out this retail procedure. NOTE: Re ...