Ford Mustang (1999-2004) Service Manual: Removal
Automatic transmission vehicles
1. Remove the flexplate. For additional information, refer to Flexplate in this section.
Manual transmission vehicles
2. Remove the flywheel. For additional information, refer to Flywheel in this section.
All vehicles
3. Using the special tools, remove the crankshaft oil slinger.
4. Using the special tools, remove the crankshaft rear oil seal.
Crankshaft Rear Oil Seal
Special Tool(s)
Installer, Crankshaft Rear Oil
Seal
303-518 (T95P-6701-DH)
Remover, Crankshaft Rear Oil
Seal
303-519 (T95P-6701-EH)
Installer, Crankshaft ...
Installation
All vehicles
1. Using the special tools, install the crankshaft rear oil seal.
Lubricate the oil seal using clean engine oil.
2. Using the special tool, install the crankshaft oil slinger.
Manu ...
Other materials:
Apply Components
There are eight apply components used to drive or hold the planetary
gearset components.
Band-Overdrive
1. The overdrive band holds the reverse clutch drum stationary in fourth gear
and manual
2. This action
causes the reverse sun gear to be h ...
Symptom Chart
Condition
Possible Sources
Action
Hard Steering or
Lack of Assist
Seized lower steering
column shaft U-joints.
Damaged, fractured
steering column
bearing(s).
Power steering pump.
Suspension
components.
...
Handle - Interior Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Remove the rivet.
3. Remove the cable clip.
4. Release the cable housing from the interior handle.
5. Release the actuating cable from the interior ha ...
