Ford Mustang (1999-2004) Service Manual: Wipers and Washers
General Specifications
Torque Specifications
Wipers and Washers
The wiper and washer system consists of the following components:
- windshield wiper mounting arm and pivot shaft
- pivot arms
- windshield wiper blades
- windshield washer reservoir
- windshield washer pump
- windshield wiper motor
- generic electronic module (GEM)
- multi-function switch
- windshield washer nozzle and bracket
- Wipers and Washers (Diagnosis and Testing)
- Wiper Blade and Pivot Arm Adjustment
- Mounting Arm and Pivot Shaft
- Motor - Windshield Wiper
- Washer Pump
- Reservoir
Keyless Entry/Computer Operated Locks
Programming -Keyless Entry Remote Transmitter
NOTE: All keyless entry remote transmitters (15K601) must be
programmed at the same time.
NOTE: All previous transmitter identification codes (TIC ...
Wipers and Washers (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for
schematic and connector
information.
Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic
and connector in ...
Other materials:
Axle Housing
Removal and Installation
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
During installation, raise the suspension to this reference mark
before tightening the
s ...
Generator - 3.8L
Removal and Installation
1. Disconnect the battery (10655). For additional information, refer
to Section.
2. Relieve the accessory drive belt (8620) tension and remove the belt
from the generator pulley.
Leave the belt in place for reinstallation ...
Crankshaft Position (CKP) Sensor - 4.6L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the A/C compressor. For additional information, refer to
Section.
3. Remove the crankshaft position (CKP) sensor.
Disconnect the connect ...
