Ford Mustang (1999-2004) Service Manual: Crankshaft Rear Oil Seal
Special Tool(s)
|
|
Installer, Crankshaft Rear Oil Seal 303-518 (T95P-6701-DH) |
 |
Remover, Crankshaft Rear Oil Seal 303-519 (T95P-6701-EH) |
 |
Installer, Crankshaft Rear Oil Seal 303-516 (T95P-6701-BH) |
 |
Remover, Crankshaft Rear Oil Slinger 303-514 (T95P-6701-AH) |
 |
Installer, Crankshaft Rear Oil Slinger 303-517 (T95P-6701-CH) |
 |
Impact Slide Hammer 100-001 (T50T-100-A) |
Material
| Item | Specification |
| Super Premium SAE 5W-20 Engine Oil XO-5W20-QSP or equivalent | WSS-M2C153- H |
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive
discs or other
abrasive means to clean the sealing surfaces. These tools cause scratches and
gouges
which make leak paths. Use a p ...
Removal
Automatic transmission vehicles
1. Remove the flexplate. For additional information, refer to Flexplate in
this section.
Manual transmission vehicles
2. Remove the flywheel. For additional informatio ...
Other materials:
Synchronizers
Disassembly and Assembly
NOTE: This procedure applies to all synchronizer assemblies.
1. NOTE: Synchronizer components are not interchangeable. During
disassembly, mark each
individual synchronizer for assembly. Synchronizer hubs and sleeves are a
selected a ...
Weld Nut Repair - Stripped Weld Nut, Restraints
Control
Module (RCM)
WARNING: To avoid accidental deployment and possible personal
injury, the backup
power supply must be depleted before repairing or replacing any front or
side air bag
supplemental restraint system (SRS) components and before servicing,
replacing, ...
Supercharger Belt Idler Pulley
Removal and Installation
1. Remove the supercharger drive belt cover.
2. Rotate the supercharger belt tensioner clockwise and remove the
supercharger belt.
3. Remove the bolt and the supercharger belt idler pulley.
4. To install, reverse the removal pro ...
