Ford Mustang (1999-2004) Service Manual: Installation
All vehicles
1. Using the special tools, install the crankshaft rear oil seal.
- Lubricate the oil seal using clean engine oil.
2. Using the special tool, install the crankshaft oil slinger.
Manual transmission vehicles
3. Install the flywheel. For additional information, refer to Flywheel in this section.
Automatic transmission vehicles
4. Install the flexplate. For additional information, refer to Flexplate in this section.
Removal
Automatic transmission vehicles
1. Remove the flexplate. For additional information, refer to Flexplate in
this section.
Manual transmission vehicles
2. Remove the flywheel. For additional informatio ...
Engine Mount
Special Tool(s)
Support Bracket, Engine
303-639
3-Bar Engine Support Kit
303-F072
Alignment Tool, Subframe
502-004
...
Other materials:
Installation
1. Install the upper arm and bushing to the mounting bracket.
1. Position the arm and bushing.
2. Install a new nut and bolt. Do not tighten at this time.
2. Connect the upper arm and bushing to the axle.
1. Position the arm and bushing.
2. Install a ...
Removal
WARNING: Always wear safety glasses when repairing an air bag
supplemental restraint
system (SRS) vehicle and when handling an air bag module. This will
reduce the risk of injury
in the event of an accidental deployment.
WARNING: Carry a live air ...
Ignition Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch d ...
