Ford Mustang (1999-2004) Service Manual: Seal
Special Tool(s)
Installer, Transmission Extension Housing Oil Seal 308-227 (T94P-7657-A) | |
Slide Hammer 100-001 (T50T-100-A) | |
Remover, Bushing 307-001 (TOOL-1175-AC) or Equivalent |
Removal
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. CAUTION: Index-mark the driveshaft flange and pinion flange, and the driveshaft slip yoke and transmission output shaft.
Remove the driveshaft. For additional information, refer to Section.
3. Using the special tools, remove the extension housing fluid seal.
Installation
1. Using the special tool, install the extension housing fluid seal.
2. CAUTION: Align the index marks.
Install the driveshaft. For additional information, refer to Section.
3. Check the transmission fluid level, add fluid if necessary.
4. Lower the vehicle.
Bearings - Inspection
NOTE: If any of the following conditions exist, install a new bearing. 1. Inspect the bearing for a bent cage. 2. Inspect bearings for galling (metal smears on roller ends). Galling is caused ...Other materials:
Heating and Defrosting
The heating and defrosting system has the following features:
Controls the temperature and, during A/C operation, reduces the relative
humidity of the air
inside the vehicle.
Delivers heated or cooled air to maintain the vehicle interior
temperature an ...
Road Test
Verify the customer concern by carrying out a road test on a smooth road. If
any vibrations are
apparent.
To maximize tire performance, inspect for signs of incorrect inflation and
uneven wear, which may
indicate a need for balancing, rotation, or front susp ...
Mass Air Flow (MAF) Sensor - Mach I
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing
element and housing are
calibrated as a unit and must be repaired as a complete assembly. Do not
damage the sensing
element (internal to housing) or possible failure to the mass air f ...