Ford Mustang (1999-2004) Service Manual: Shield
Removal
1. Remove the brake disc (2C026). For additional information, refer to Disc in this section.
2. Remove the brake disc shield bolts.
Installation
1. Follow the removal procedure in reverse order.
Brake Caliper Support Bracket
Removal
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. CAUTION: Do not allow the rear disc brake caliper (2552) to
hang from the rear
wheel brake hose (2A442)
...
Caliper (Disassembly and Assembly)
Special Tool(s)
Rear Caliper Piston Adjuster
206-026 (T87P-2588-A)
Rear Caliper Spring
Compressor Set
206-S027 (T87P-2588-B)
Disassembly
1. Remove the rear disc brake calip ...
Other materials:
Crankshaft Front Seal
Special Tool(s)
Installer, Front Cover Oil Seal
303-335 (T88T-6701-A)
Installer, Crankshaft Front Oil
Seal
303-474 (T94P-6701-AH)
Remover, Oil Seal
303-409 (T92C-6700-CH)
Material
Removal
1. Remove the crankshaft pulley. ...
Gearshift Rail and Fork
Disassembly and Assembly
1. Using a 5/32-inch drift and a hammer, remove and discard the split pin.
Slide the shift fork from
the shift rail.
2. Remove the gearshift fork inserts.
3. CAUTION: Support the shift rail to prevent damage to the parts.
Positio ...
Mass Air Flow (MAF) Sensor - Mach I
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing
element and housing are
calibrated as a unit and must be repaired as a complete assembly. Do not
damage the sensing
element (internal to housing) or possible failure to the mass air f ...
