Ford Mustang (1999-2004) Service Manual: Suspension System - General Information
Alignment Specifications
General Specifications
Torque Specifications
| Description | Nm | lb-ft |
| Front suspension camber adjustment plate bolt | 40 | 30 |
| Front suspension camber adjustment plate nuts | 40 | 30 |
| Rear camber adjustment nut | 90 | 66 |
| Toe link jam nuts | 55 | 41 |
| Tie-rod jam nuts | 55 | 41 |
- Wheel Alignment Angles
- Suspension System
- Camber and Caster Adjustment - Front
- Camber Adjustment - Rear
- Toe Adjustment - Front
- Toe Adjustment - Rear
Suspension
...
Wheel Alignment Angles
Camber and toe are adjustable on the front suspension systems. Front camber
is adjusted by moving
the top of the strut and spring assembly. Rear camber is adjusted by means of
eccentric cams on the
...
Other materials:
Disassembly
1. Remove the No. 1 selective pump support thrust washer.
2. Remove the front pump support.
1. Remove the bolts.
2. Remove the front pump support.
3. Remove the seal rings.
4. Remove the inner and outer pump gerotor gears.
5. Carefully pry spring ...
Symptom Chart
Condition
Possible Sources
Action
Dogtracking
Excessive rear
thrust angle.
Front or rear
suspension
components.
Drive axle
damaged.
CHECK the wheel alignment.
ADJUST as necessary
INSPE ...
Clutch Pedal Position (CPP) Switch
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Disconnect the connector.
3. Remove the bolt and the clutch pedal position (CPP) switch.
Installation
1. To install, reverse the removal procedure. ...
