Ford Mustang (1999-2004) Service Manual: Timing Drive Components
Special Tool(s)
|
|
Holding Tool, Crankshaft 303-448 (T93P-6303-A) |
Installation
All vehicles
1. Position the engine front cover gasket on the engine front cover.
2. NOTE: If the engine front cover is not secured within four minutes, the
sealant must be removed
and the sealing ...
Removal
CAUTION: Since the engine is not free-wheeling, if the crankshaft or
the camshafts are
moved in any manner during removal and installation, the crankshaft and the
camshafts must
be re-synchronized.
...
Other materials:
Air Conditioning (A/C) System Check - Retail Procedure
NOTE: This Retail Procedure is not eligible for claiming on Ford
paid repairs (warranty and ESP).
NOTE: The engine should be run at idle for 10 minutes with the air
conditioning on and set to MAX A/C
before carrying out this retail procedure.
NOTE: Re ...
Installation
NOTE: Do not use a fiber disc to clean the surfaces. Fibers from
the disc can get into the oil pan and
oil and clog the oil bypass valve.
1. Clean and inspect the cylinder head for flatness.
2. Install a new head gasket on the cylinder block with the sm ...
Driveline System - General Information
Driveline Angles @ Curb Specifications
All driveshaft and pinion angles point downward.
General Specifications
a: Service refill capacities are determined by filling the axle 6.3 mm (0.25
in [1/4 in]) to 14.3 mm (0.57 in
[5/16 in]) below the bottom of the ...

