Ford Mustang (1999-2004) Service Manual: Valve Cover - LH

Removal and Installation

1. Position the ignition wires (12281) aside.

Valve Cover -LH

2. Disconnect the positive crankcase ventilation (PCV) valve (6758).

Valve Cover -LH

3. Remove the ignition coil and position aside.

1. Disconnect the electrical connector.

2. Disconnect the accelerator control cable retainer.

3. Remove the bolts.

Valve Cover -LH

4. Remove the LH valve cover (6A565).

  • Inspect the gasket (6584) and install a new gasket if necessary.

Valve Cover -LH

5. To install, reverse the removal procedure.

    Installation
    1. NOTE: If the lower intake manifold is not secured within four minutes, the sealant must be removed and the sealing area cleaned with metal surface cleaner. Allow to dry until there is no sign ...

    Valve Cover RH
    Removal and Installation 1. Remove the throttle body. For additional information, refer to Section. 2. Disconnect the crankcase vent hose. 3. Remove the differential feedback exhaust gas recirc ...

    Other materials:

    Handles, Locks, Latches and Mechanisms
    General Specifications Torque Specifications LOCK REPAIR/REPLACEMENT SPECIFICATIONS ...

    Battery Disconnect
    WARNING: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery, always shield your face and protect your eyes. Always provide ventilation. ...

    Removal
    1. Disconnect the battery ground cable. 2. Remove the air cleaner outlet tube. For additional information, refer to Section. 3. Remove the radiator sight shield. 4. Install the special tool. 5. Using the special tools, support the engine. 6. Raise and sup ...