Ford Mustang (1999-2004) Service Manual: Valve Cover RH

Removal and Installation

1. Remove the throttle body. For additional information, refer to Section.

2. Disconnect the crankcase vent hose.

Valve Cover RH

3. Remove the differential feedback exhaust gas recirculation (EGR) system vacuum hoses and the bracket bolts. Position the bracket assembly aside.

Valve Cover RH

4. Disconnect the EGR tube.

Valve Cover RH

5. Remove the EGR tube.

Valve Cover RH

6. Position the spark plug wires aside.

Valve Cover RH

7. Remove the RH valve cover.

Valve Cover RH

8. To install, reverse the removal procedure.

  • Install a new valve cover gasket as necessary.
    Valve Cover - LH
    Removal and Installation 1. Position the ignition wires (12281) aside. 2. Disconnect the positive crankcase ventilation (PCV) valve (6758). 3. Remove the ignition coil and position aside. 1. ...

    Crankshaft Pulley
    Special Tool(s) Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D) Remover, Crankshaft Vibration Damper 303-176 (T82L-6316-B) Installer, Crankshaft Damper/C ...

    Other materials:

    Brake Caliper Anchor Plate
    Removal 1. Remove the pads. For additional information, refer to Pads in this section. 2. Remove the anchor plate (2B292). 1. Remove and discard the anchor plate bolts. 2. Remove the anchor plate. Installation 1. CAUTION: Use correct t ...

    Steering Column Switches (Diagnosis and Testing)
    Refer to Wiring Diagrams Cell 13 , Power Distribution for schematic and connector information. Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic and connector information. Refer to Wiring Diagrams Cell 85 , Headlamps for schematic and co ...

    Component Tests
    Battery-Load Test 1. With the engine running, turn the A/C on, the blower motor on high speed and the headlamps on high beam. 2. Increase the engine speed to approximately 2,000 rpm. The voltage should increase a minimum of 0.5 volt above the ba ...