Ford Mustang (1999-2004) Service Manual: Warning Devices
Warning Devices
The warning device system consists of the following components:
- door ajar switches
- generic electronic module (GEM)
- key-in-ignition warning switch
- safety belt switch
- parklamp switch
Switch - Horn
Removal
1. Remove the driver side air bag module (043B13). Refer to Section.
2. Remove the switches.
1. Disconnect the horn wire from the switches.
2. Remove the horn switch screws and ...
Gauges And Warning Devices
Refer to Wiring Diagrams Cell 59 , Generic Electronic Module for
schematic and connector
information.
Refer to Wiring Diagrams Cell 60 , Instrument Cluster for schematic and
connector infor ...
Other materials:
Heater Core Backflushing
Special Tool(s)
Flush Kit
164-R3658 or equivalent
Drain Kit
164-R3662 or equivalent
Material
Item
Specification
Motorcraft Premium Cooling
System Flush
VC-1 or equivalent
ESR-M14P7-A
Motorcraft Premium ...
Moulding - Rocker Panel
Removal
1. Remove the front rocker panel moulding screw.
2. Remove the strip.
3. Remove the rear rocker panel moulding screw.
4. Remove the pin-type retainers and the rocker panel moulding.
Installation
1. To install, reverse the removal procedure. ...
Idle Air Control (IAC) Valve - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. NOTE: Discard the idle air control (IAC) valve gasket.
Remove the IAC valve.
Disconnect the connector.
Remove the two bolts, the IAC valve and ...
