Ford Mustang (1999-2004) Service Manual: Water Pump

Removal and Installation

1. Disconnect the battery ground cable.

2. Drain the coolant. For additional information, refer to Supercharger Cooling System Draining, Filling and Bleeding in this section.

3. Remove the retainer and position the inner fender well aside.

Water Pump

4. Disconnect the water pump electrical connector.

Water Pump

5. Disconnect the coolant hoses.

Water Pump

6. Remove the bolts and the water pump.

Water Pump

7. To install, reverse the removal procedure.

    Supercharger Cooling System Flushing
    1. WARNING: Never remove the pressure relief cap while the engine is operating or when the cooling system is hot. Failure to follow these instructions can result in damage to the cooling system or e ...

    Radiator
    Removal and Installation 1. Drain the coolant. For additional information, refer to Supercharger Cooling System Draining, Filling and Bleeding in this section. 2. NOTE: RH is shown LH is similar. D ...

    Other materials:

    Climate Control System (Description and Operation)
    WARNING: To avoid accidental deployment and possible injury, the air bag system backup power supply must be depleted before repairing any climate control components. To deplete the backup power supply, disconnect the battery ground cable and wait one minute ...

    Pinpoint Tests
    NOTE: Reinstall or install new evaporative emission hose clamps removed or damaged during testing procedures. PINPOINT TEST A: DTC P0442 SMALL LEAK IN EVAP SYSTEM Test Step Result / Action to Take NOTE: Condition P0442 DTC set: less than 0.62 ...

    Steering Column Shaft
    Removal and Installation 1. CAUTION: Do not allow the steering column shaft to rotate while intermediate shaft is disconnected or damage to the clockspring can result. If there is evidence that the steering column shaft has rotated the clockspring must be re ...