Ford Mustang (1999-2004) Service Manual: Assembly
1. Lubricate the differential side gear thrust washers and the differential side gear journals, and assemble the washers to the gears.
- Use SAE 80W-90 Premium Rear Axle Lubricant XY-80W90-QL or equivalent meeting Ford specification WSP-M2C197-A.
2. Lubricate the differential pinion thrust washers and the differential pinion gears, and assemble the washers to the gears.
- Use SAE 80W-90 Premium Rear Axle Lubricant XY-80W90-QL or equivalent meeting Ford specification WSP-M2C197-A.
3. Position the differential side gear and thrust washer assemblies in the differential case.
4. Engage the differential pinion gears with the differential side gears and rotate the pinion gears to align with the differential pinion shaft bore.
5. Insert the differential pinion shaft.
- Align the hole in the differential pinion shaft with the hole in the differential case.
6. NOTE: If a new bolt is unavailable, coat the original bolt threads with Threadlock and Sealer EOAZ-19554-AA or equivalent meeting Ford specifications WSK-M2G351-A5 prior to installation.
Install a new bolt finger-tight.
7. Using the special tool, install the new differential bearings, if removed.
8. Position the ring gear and the differential case. Align the bolt holes by starting two bolts through the holes in the differential case and the ring gear. Press the ring gear on the differential case.
9. Install the bolts.
- Apply Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSK-M2G349-A1 to the bolt threads.
10. Install the differential case. For additional information, refer to Differential Case in this section.
Disassembly
1. Remove the differential assembly from the differential housing. For
additional information, refer
to Differential Case in this section.
2. Remove the bolts.
3. CAUTION: Do not damage the thread ...
Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear
General Specifications
Torque Specifications
Description
Nm
lb-ft
lb-in
Bolt retaining the differential pinion shaft to the
differential case
30
22
-
Bolt retaining t ...
Other materials:
Component Tests
Engine Oil Leaks
NOTE: When diagnosing engine oil leaks, the source and location of
the leak must be positively
identified prior to repair.
Prior to carrying out this procedure, clean all sealing surface areas with a
suitable solvent to remove all
tra ...
Rocker Arm
Removal
CAUTION: If removing more than one rocker arm (6564), mark the
components removed
for correct location.
1. Remove the valve covers. For additional information, refer to
Valve Cover-LH and Valve Cover
RH in this section.
2. Remove the rocker ...
Component Test
Windshield Wiper Motor
CAUTION: Do not handle the wiper motor abusively when
diagnosing the wiper
operations. Failure to follow this caution may result in damage to the
motor magnets and will
make the wiper motor inoperative. Rough handling of new ...
