Ford Mustang (1999-2004) Service Manual: Floor Console
Removal and Installation
All vehicles
1. Disconnect the battery ground cable. For additional information, refer to Section .
2. Apply the parking brake.
Vehicles with automatic transmission
3. Place the selector lever in the 1 position.
Vehicles with manual transmission
4. Remove the gearshift lever handle.
All vehicles
5. Remove the floor console finish panel.
- Disconnect the electrical connector.
6. Open the floor console glove compartment door.
7. Remove the floor console screws.
8. Disconnect the floor console electrical connector.
9. Remove the screws and the floor console.
10. To install, reverse the removal procedure.
Instrument Panel - Center Finish Panel
Removal and Installation All vehicles 1. Disconnect the battery ground cable. For additional information, refer to Section. Vehicles with automatic transmission 2. Place the selector lever ...Handles, Locks, Latches and Mechanisms
General Specifications Torque Specifications LOCK REPAIR/REPLACEMENT SPECIFICATIONS ...Other materials:
Removal
1. Disconnect the battery ground cable. For additional information, refer to
Section.
2. Drain the cooling system. For additional information, refer to Section.
3. Recover the refrigerant. For additional information, refer to Section.
4. Remove the air cle ...
Negative and Positive Camber
Camber is the vertical tilt of the wheel (1007) when viewed from the front.
Camber can be positive or
negative and has a direct effect on tire wear.
Caster
Item
Part Number
Description
1
-
Positive caster
2
-
True vertical
...
Switch
Removal
1. Remove the climate control assembly. For additional information, refer to
Control Assembly in
this section.
2. NOTE: All three switches are removed the same.
Remove the knob.
3. Remove the screw.
4. Rotate the switch and remove it from the cont ...