Ford Mustang (1999-2004) Service Manual: Lamp Assembly - Fog Lamp (GT)
Removal
1. Raise and support the vehicle.
2. Remove the screw.
3. Partially lower the vehicle and remove the fog lamp assembly.
1. Disconnect the electrical connector.
2. Remove the two screws.
3. Remove the fog lamp assembly and replace the bulb if necessary.
Installation
1. NOTE: Be sure the fascia clip is correctly installed on the bottom side of the fog lamp assembly bracket.
To install, reverse the removal procedure.
Lamp Assembly -Fog Lamp (Cobra)
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to Section.
2. Remove the fog lamp assembly.
1. Disconnect the electrical connector.
2. Remove the four screws.
3. To install, reverse the removal procedure.
Lamp Assembly - Headlamp
Removal
1. NOTE: Make sure that the headlamp switch and the ignition switch are
in the OFF position.
Raise the headlamp retainers.
2. Remove the headlamp assembly.
Disconnect the electrical ...
Lamp Assembly - Rear
Removal
1. Position the luggage compartment trim aside.
Remove the two retainers.
2. Remove the four rear lamp nuts.
3. Remove the rear lamp assembly, disconnect the electrical connectors an ...
Other materials:
Key Programming - Enable/Disable Spare Key
Programming
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent
diagnostic tool
NOTE: The spare key programming switch is a diagnostic tool programmable
switch that provides the
ca ...
Piston - Ring-to-Groove Clearance
1. Inspect the piston for ring land damage or accelerated wear.
2. Measure the piston ring-to-groove clearance.
Refer to the appropriate section in Group for the procedure.
If out of specification, install new components as necessary. Refer
to the a ...
Valve Cover RH
Removal and Installation
1. Remove the throttle body. For additional information, refer to
Section.
2. Disconnect the crankcase vent hose.
3. Remove the differential feedback exhaust gas recirculation (EGR) system
vacuum hoses and
the bracket bolts. Po ...
