Ford Mustang (1999-2004) Service Manual: Valve Cover RH
Removal and Installation
1. Remove the throttle body. For additional information, refer to Section.
2. Disconnect the crankcase vent hose.
3. Remove the differential feedback exhaust gas recirculation (EGR) system vacuum hoses and the bracket bolts. Position the bracket assembly aside.
4. Disconnect the EGR tube.
5. Remove the EGR tube.
6. Position the spark plug wires aside.
7. Remove the RH valve cover.
8. To install, reverse the removal procedure.
- Install a new valve cover gasket as necessary.
Valve Cover - LH
Removal and Installation 1. Position the ignition wires (12281) aside. 2. Disconnect the positive crankcase ventilation (PCV) valve (6758). 3. Remove the ignition coil and position aside. 1. ...Crankshaft Pulley
Special Tool(s) Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D) Remover, Crankshaft Vibration Damper 303-176 (T82L-6316-B) Installer, Crankshaft Damper/C ...Other materials:
Stoplamps
Refer to Wiring Diagrams Cell 90 , Turn/Stop/Hazard Lamps for
schematic and connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Inspection and Verification
1. Verify the customer concerns.
2. Visually ...
Manual Transaxle/Transmission - T56
General Specifications
Torque Specifications
...
Assembly
1. CAUTION: 118 ml (4 oz) of the specified Ford Friction Modifier must
be used in the
axle.
Lubricate each steel clutch plate and soak all friction plates for no less than
15 minutes.
Use Additive Friction Modifier C8AZ-19B546-A or equivalent meeting Ford ...