Ford Mustang (1999-2004) Service Manual: Rear Drive Axle/Differential - Ford 8.8-Inch IRS
General Specifications
Torque Specifications
a: Use Stud and Bearing Mount EOAZ-19554-BA or equivalent meeting Ford specification WSKM2G349- A1.
b: With pinion flange yoke seal.
- Rear Drive Axle and Differential
- Stub Shaft Pilot Bearing and Seal
- Drive Pinion Flange
- Pinion Seal
- Axle Housing
- Axle
Assembly
1. CAUTION: 118 ml (4 oz) of the specified Ford Friction Modifier must be used in the axle. Lubricate each steel clutch plate and soak all friction plates for no less than 15 minutes. Use Additiv ...Rear Drive Axle and Differential
The differential housing (4010) consists of a cast aluminum housing and a cast aluminum differential housing cover (4033). The differential housing cover uses silicone sealant as a ...Other materials:
Inspection and Verification
WARNING: Batteries contain sulfuric acid. Avoid contact with
skin, eyes, or clothing.
Also, shield your eyes when working near batteries to protect against
possible splashing of the
acid solution. In case of acid contact with skin or eyes, flush
...
Front Seat Cushion
Disassembly and Assembly
All vehicles
1. Remove the seat track. For additional information, refer to Seat Track
in this section.
2. Remove the seat backrest. For additional information, refer to Front Seat
Backrest in this
section.
Vehicles with powe ...
911 Assistâ„¢
WARNING: Unless the 911 Assist setting is set on prior to a
crash, the system will not dial for help which could delay
response time, potentially increasing the risk of serious injury or death
after a crash.
WARNING: Do not wait for 911 Assist to make an emerg ...