Ford Mustang (1999-2004) Service Manual: Removal
1. Remove the A/C compressor (19703). For additional information, refer to Air Conditioning (A/C) Compressor-3.8L or Air Conditioning (A/C) Compressor-4.6L in this section.
2. Remove the bolt.
1. Hold the A/C disc and hub assembly (19D786) with the special tool.
2. Remove the bolt.
3. Remove the A/C disc and hub assembly and the A/C clutch hub spacer (19D648).
1. Thread an 8 x 1.25 mm bolt into the A/C clutch to force it from the compressor shaft.
2. Lift the A/C disc and hub assembly and the A/C clutch hub spacer from the compressor shaft.
4. Remove the pulley snap ring.
5. Remove the A/C clutch pulley (2E884).
6. CAUTION: Do not use air tools. The A/C clutch field coil (19D798) can be easily damaged.
Remove the A/C clutch field coil.
1. Note the location of the A/C clutch field coil electrical connector.
2. Install the special tool on the nose opening of the A/C compressor.
3. Install the special tool.
4. Remove the A/C clutch field coil.
Clutch And Clutch Field Coil
Special Tool(s) 2-Jaw Puller 205-D026 (D80L-1002-L) or equivalent Installer, A/C Compressor Coil 412-065 (T89P-19623-EH) Holding Fixture, Compressor Clutch ( ...Installation
1. Clean the A/C disc and field coil and pulley mounting surfaces. 2. CAUTION: Do not use air tools. The A/C clutch field coil can be easily damaged. Install the A/C clutch field coil. 1. Place th ...Other materials:
Starter Motor - 3.8L
Removal
WARNING: When servicing starter motor (11002) or carrying out other
underhood work in
the vicinity of the starter motor, be aware that the heavy gauge battery
input lead at the starter
solenoid (11390) is "electrically hot" at all times. A prote ...
Driveline System - General Information
Driveline Angles @ Curb Specifications
All driveshaft and pinion angles point downward.
General Specifications
a: Service refill capacities are determined by filling the axle 6.3 mm (0.25
in [1/4 in]) to 14.3 mm (0.57 in
[5/16 in]) below the bottom of the ...
Removal
CAUTION: Electronic modules are sensitive to static electrical
charges. If exposed to
these charges, damage may result.
1. Remove the driver air bag module. For additional information,
refer to Section.
2. Remove the passenger air bag module. For ...