Ford Mustang (1999-2004) Service Manual: Retractor - Front Seat Safety Belt, Coupe
Special Tool(s)
Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) |
Removal
1. Remove the quarter trim panel (31012). For additional information, refer to Section.
2. Using the special tool, remove the bolt and the safety belt retractor.
- Remove the mastic seal.
3. Using the special tool, remove the safety belt anchor bolt.
4. Using the special tool, remove the D-ring bolt.
Installation
NOTE: Make sure the retractor tongue faces inboard.
NOTE: Make sure the safety belt is not twisted.
1. The shipping clip must remain attached prior to the installation of the retractor into the vehicle.The clip must be removed after the retractor is installed.
2. Position the safety belt anchor. Using the special tool, install the safety belt bolt.
3. Install a new mastic seal around the safety belt retractor before installing the retractor in the vehicle.
4. Position the safety belt retractor. Using the special tool, install the bolt.
5. Using the special tool, install the D- ring bolt.
6. Install the quarter trim panel. For additional information, refer to Section.
7. The shoulder belt must pass through the belt holder on the top of the seatback.
8. Check the active restraint system for correct operation.
Safety Belt Tongue Rotated on Belt
1. Grasp the belt tongue and pull the belt webbing down to form a loop through the upper (longer and narrower) slot in the tongue. 2. Rotate and fold the belt webbing over itself within the slot to ...Retractor - Front Seat Safety Belt, Convertible
Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal 1. Remove the quarter trim panel (31012). For additional information, refer to Section. 2. Remove the nut and ...Other materials:
Interior Trim and Ornamentation
General Specifications
Torque Specifications
Interior Trim
The interior trim consists of:
A-pillar lower trim panels
door trim panels
headliner (coupe)
package tray trim panel (coupe)
quarter trim panels
upper quarter trim panels (coup ...
Cooling System Draining, Filling and Bleeding
Material
Item
Specification
Motorcraft Premium Gold
Engine Coolant
VC-7-A (in Oregon VC-7-B)
(yellow color)
WSS-M97B51-
A1
Draining
WARNING: Never remove the pressure relief cap while the engine is
operating or when the
cooling syst ...
Removal
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. WARNING: Brake fluid contains polyglycol ethers and polyglycols.
Avoid contact
with eyes. Wash hands thoroughly after handling. If brake fluid contacts
eyes, flush eyes ...