Ford Mustang (1999-2004) Service Manual: Throttle Body

Removal

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.

CAUTION: The throttle body bore and plate area have a special coating and cannot be cleaned.

1. Remove the air cleaner outlet tube (9B659). For additional information, refer to Section.

2. Disconnect the throttle position (TP) sensor electrical connector.

Throttle Body

3. Disconnect the accelerator controls.

  • Disconnect the accelerator cable (9E926).
  • Disconnect the speed control cable (9A825).
  • Disconnect the return spring.

Throttle Body

4. NOTE: Discard the throttle body gasket.

Remove the throttle body.

  • Remove the bolts.
  • Remove the throttle body.

Throttle Body

Installation

1. To install, reverse the removal procedure.

    Fuel Charging And Controls
    The fuel injection supply manifold (9F792): delivers fuel to the fuel injector. receives fuel from the fuel supply line. The throttle body (9E926): controls air supply to the upper intake manifo ...

    Fuel Injectors
    Removal WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may be ignited. ...

    Other materials:

    Index Card
    Place an index card or a piece of paper between the weatherstrip and the sealing surface, then close the door. Slowly withdraw the index card or paper after the door is closed and check the amount of pressure on the weatherstrip. There should be a medium amo ...

    Emission control system
    WARNING: Do not park, idle, or drive your vehicle in dry grass or other dry ground cover. The emission system heats up the engine compartment and exhaust system, which can start a fire. WARNING: Exhaust leaks may result in entry of harmful and potentially leth ...

    Disc and Pressure Plate - 4.6L (4V) Engine
    Special Tool(s) Clutch Aligner 308-020 (T74P-7137-K) Material Item Specification Premium Long Life Grease XG-1-C ESA-M1C75-B 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove t ...