Ford Mustang (1999-2004) Service Manual: Fuel Injection Supply Manifold

Installation

1. Position the fuel charging wiring in the vehicle and attach to the rear of the intake manifold. 2. NOTE: Make sure the locking clips are fully engaged into the bracket. Reposition the accel ...

Removal

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable mixtures are always present and may be ignited. Failure ...

Other materials:

Acceleration Control (Description and Operation)
Component Locations   The throttle is controlled by the accelerator cable which is connected to the accelerator pedal and shaft. The accelerator pedal and shaft should travel smoothly from the idle to the wide-open throttle (WOT) positions. Hesi ...

Crankshaft Position (CKP) Sensor - 3.8L
Removal 1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the crankshaft position (CKP) sensor. Disconnect the connector. Remove the bolts and the sensor. Installation 1. To install, reverse ...

Disc
Removal 1. Remove the front disc brake caliper anchor plate (2B292). For additional information, refer to Brake Caliper Anchor Plate in this section. 2. Match mark the hub (1104) and the brake disc (1125). 3. If necessary, remove and discard the kee ...