Ford Mustang (1999-2004) Service Manual: Fuel Charging and Controls - 4.6L (2V)
General Specifications

Torque Specifications

- Fuel Charging And Controls
- Throttle Body
- Fuel Injectors
- Fuel Charging Wiring Harness
- Fuel Injection Supply Manifold
Supply Manifold
Removal and Installation
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel related components. Highly flammable mixtures are
always present
an ...
Fuel Charging And Controls
The fuel injection supply manifold (9F792):
delivers fuel to the fuel injector.
receives fuel from the fuel supply line.
The throttle body (9E926):
controls air supply to the upper intake manifo ...
Other materials:
Headlamps
Refer to Wiring Diagrams Cell 85 , Headlamps for schematic and
connector information.
Special Tool(s)
73III Automotive Meter or
equivalent
105-R0057
Inspection and Verification
1. Verify the customer concern by operating the headlamps. ...
Cable and Conduit
Removal
NOTE: The RH rear is shown, the LH is similar.
1. CAUTION: If any component in the parking brake system requires
repair or if the
rear axle housing (4010) is removed, the cable tension must be released.
Release the cable tension. For additional ...
Engine Coolant Temperature (ECT) Sensor - 4.6L (2V)
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Partially drain the cooling system. For additional information, refer
to Section.
3. Disconnect the engine coolant temperature (ECT) sensor (12A648) ...
