Ford Mustang (1999-2004) Service Manual: Ignition Lock Cylinder - Functional
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the ignition switch lock cylinder (11582).
1. Insert the ignition key and turn to the RUN position.
2. Using a 1/8-inch drift, press the ignition switch lock cylinder release pin through the access hole while pulling out the ignition switch lock cylinder.
3. To install, reverse the removal procedure.
- Verify ignition switch lock cylinder operation.
Handle - Interior Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Remove the rivet.
3. Remove the cable clip.
4. Release the cable housing from the interior h ...
Ignition Lock Cylinder - Non-Functional
Removal and Installation
1. NOTE: Make sure the front wheels are in the straight-ahead
position.
Disconnect the battery ground cable (14301) and wait at least one minute
to allow the deplet ...
Other materials:
Accessory Drive - Cobra
Component Locations -Supercharger Accessory Drive
Component Location -Accessory Drive
...
Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the
brake master cylinder
(2140). The hydro-boost bleed screw, located near the dash on the
hydro-booster
casting, is for the booster cavity filled with power steering fluid, not
brake fluid. ...
Air Cleaner Outlet Pipe - 3.8L
Removal and Installation
1. Remove the air cleaner outlet tube.
1. Loosen the clamps.
2. Disconnect the hose.
3. Remove the tube.
2. To install, reverse the removal procedure.
Air Cleaner Outlet Pipe -4.6L (2V)
Removal and Installation
1. Dis ...
