Ford Mustang (1999-2004) Service Manual: Intake Manifold

Engine
      A modular engine is built around four modules: the intake module the cylinder head module (RH) the cylinder head module (LH) the lower engine module While no ...

Removal
1. Drain the engine cooling system. 2. Remove the air cleaner outlet tube. 3. Disconnect the fuel line. 4. Disconnect the upper radiator hose from the water outlet connector. 5. Disconnect ...

Other materials:

Disassembly
1. Remove the No. 1 selective pump support thrust washer. 2. Remove the front pump support. 1. Remove the bolts. 2. Remove the front pump support. 3. Remove the seal rings. 4. Remove the inner and outer pump gerotor gears. 5. Carefully pry spring ...

Installation
1. Install the upper intake manifold gasket. 2. Install the intake manifold and bolts in the sequence shown. 3. Install the PCV valve-to-intake manifold tube. 4. Connect the vacuum hoses and the electrical connector to the EGR vacuum regulator soleno ...

Removal
NOTE: This procedure applies to both the LH and RH halfshafts. 1. CAUTION: The vehicle must be on level ground and at curb height. Mark the rear shock absorber relative to the protective sleeve. During installation, raise the suspension to this reference ...